- Machine Confirming to IS 6893-1988 Latest (For Technical Evaluation)
- Machine Material Confirming to IS 210 Latest(For Casting )
- Machine Confirming Full power cutting load test to full length Turning capacity of Machine 
- Availability of Drawing for Foundation

Driving Plate With Peg 
Coolant Equipment & swarf tray 
Splash Guard 
Spindle Reduction Sleeve 
60 Deg Dead Centre-2 Nos 
Quick change tool post with Tool Holders 
Quick indexible Square tool post 
A Set of Operating Instructions Manual & a set of operating tools 
3 Jaw Self Centering Chuck

MODEL       CL300

- Distance Between centers x Swing over Bed 500 x 300 mm
- Swing Over Bed 200 mm
- Center Height in 125 mm 
- Swing Over Cross Slide in 135 mm 
- Swing Over Carriage Wing in 145 mm 
- Type of Bed Flat Shaped
- Length of Bed in 300 mm 
- Width of Bed in 150 mm
- Maximum Feed Force 2
- Maximum Facing Diameter in 100 mm
- Maximum Weight of work piece that can be held between chuck and supported by Live center in kg30 kilogram
- Maximum Weight of work piece that can be held between chuck and supported by dead center in kg30 kilogram
- Maximum Torque on Spindle in NM2 
- Size of Spindle in 2 mm
- Type of Chuck 3 Jaw Self Centered
- Travel of Cross Slide in 150 mm
- Main Motor Power in 3 kw
- Types of power supply 3 Phase
- Coolant Pump output in kw as per IS 2161:1962 Latest0.12
- Minimum Chucking Diameter in 200 mm
- Maximum Chucking Diameter in 200 mm
- Tail Stock Sleeve Diameter in 120 mm
- Sleeve Travel Type(Tail Stock) Manual
- Length of Lathe Machine in 2500 mm
- Width of Lathe Machine in 1610 mm
- Height of Lathe Machine in 1570 mm
- Weight of Lathe Machine with electrical and standards Accessories 1000 kg
- Type of Spindle CROSS X-AXIS TRA. 100
- Size of Spindle in 2 mm 
- Type of Spindle Nose A2-4
- Taper in Spindle Bore as per IS 2582-1972 with Latest amndmt LONGITUD Z-AXIS-300
- Taper Bore in Spindle Sleeve as per IS 1715-1986 with Latest amndmt RAPID FEED 20M
- Bore in Spindle in 34 mm
- Range of Spindle Speed in Forward Direction in rev/min 50-2500RPM
- Range of Spindle Speed in Reverse Direction in rev/min STATION-2
- Travel of Cross Slide in 150 mm
- Type of Tool Holder BAR CAPA.22MM
- Tool Shank Size as per IS 1983:1958 latest in 20X20MM 
- Tailstock Spindle Taper as per IS 1715: 1986  with latest  : Accuracy 0.010 
- Maximum Offset of Tailstock on either side of Center Line in mm : 0 
- Noise emitted by Machine in db as per IS 10998:1984 latest 0.15
- Mechanical Guarding as per IS 9474 :1980 latest 
- In possession of Technical Evaluation report as per IS :11118 
- Main Spindle Bearing confirming Pre-loaded of Standard make 
- Coolant Pump output in kw as per IS 2161:1962 Latest 0.12
- Coolant Pump Discharge at maximum working height as per IS 2161:1962 with latest amndmt in l/min 150